![]() 3: 7 hours - Herrington and Lopez-Alegria successfully completed installation of 33 spool positioning devices around the outside of the station. The move cleared the P1 tracks so the Canadarm 2 can move on them via the Mobile Transporter and Mobile Base System.Ī final task was reconnecting a cable on the WETA installed 2 days earlier.ĮVA No. Working from the Canadarm2, Herrington lifted the CETA cart to the S1 truss where he attached it to the tracks and secured it to its sister CETA, delivered on STS-112. They released launch locks on the P1 radiator beams. They also installed a second WETA, this one on the P1 truss. They removed the starboard keel pin, moving it to the proper location and stowing it in the P1 truss. 2: 6 hours, 10 minutes - On Thanksgiving Day, Lopez-Alegria and Herrington connected two fluid jumpers between the P1 and S0 trusses, linking plumbing for ammonia in the station's cooling system. They also installed Node Wireless video system External Transceiver Assembly (WETA) antennas allowing reception from spacewalkers' helmet cameras without a shuttle present.ĮVA No. 1: 6 hours, 45 minutes - Mission Specialists Michael Lopez-Alegria and John Herrington hooked up electrical connections between the P1 truss and station, installed spool positioning devices that will ensure quick disconnect devices in fluid lines function properly, and released launch locks on the Crew and Equipment Translation Aid (CETA) cart. Whitson and Bowersox maneuvered the P1 to its installation position.ĮVA No. Prior to the first spacewalk, Commander Jim Wetherbee removed the P1 truss from Endeavour's payload bay, using the shuttle's robotic arm, and handed it off to the station's Canadarm2. ![]() While Endeavour was docked to the space station, Expedition 5 NASA Science Officer Peggy Whitson and Expedition 6 Commander Ken Bowersox replaced two valves and cleared debris from vent lines of the Carbon Dioxide Removal Asembly (CDRA) in the station's U.S. Endeavour brought more than 2,500 pounds of material to the station.Īmong the transfer were science experiments, the PCG-STES and PGBA returning to Earth and the PCG-STES Unit 10 moving onto the station. Over the course of the 14-day mission, the STS-113 crew and the Expedition Six crew combined to install the new P1 truss to the International Space Station, perform three spacewalks to outfit and activate the truss, and transfer supplies and equipment between the two spacecraft. 23 due to poor weather conditions at the Transoceanic Abort Landing sites. The launch was again postponed 24 hours to Nov. Inspections of the arm for damage postponed launch until Nov. A fatigued flexible hose was found to be the cause and was replaced, along with another similar hose.Īnother problem surfaced when a platform used to access the oxygen line bumped the robotic arm in the payload bay. 18 so that technicians could troubleshoot and repair the leak. Launch was tentatively set for no earlier than Nov. 11 was postponed when higher than allowable oxygen levels were detected in the orbiter's mid-body. Image above: STS-113 Crew photo with Commander Jim Wetherbee, Pilot Paul Lockhart, Mission Specialists Michael Lopez-Alegria and John Herrington. ![]() Mission Duration: 13 days, 18 hours, 48 minutes and 38 seconds Landing Site: Kennedy Space Center, Florida After that, the effort will begin to lift the massive external fuel tank, known as ET-94, into vertical position, followed by the intricate lifting of the shuttle itself by a large crane to its new location and positioning into a 200-foot-tall vertical display.Launched: November 23, 2002, 7:49:47.079 p.m. The effort began with the intricate installation of “aft skirts,” on which the solid rocket motors will be stacked to form the solid rocket boosters. The new center is not expected to open until 2025, but Thursday marked the beginning of a six-month “Go for Stack” process. ![]() But construction began last year on the center’s $400 million Samuel Oschin Air and Space Center, which will house the shuttle in the vertical launch position with the rocket boosters and fuel tank. The shuttle has been on display horizontally at the Science Center for 11 years. California Science Center officials on Thursday, July 20, began the process of reconfiguring the space shuttle Endeavour into a planned “vertical display” with two rocket boosters and an external fuel tank, marking the first time such a feat will have been performed with a shuttle outside of a NASA facility. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |